2: Screw the Coil Head into the Airflow Adjustment Base.
(Make sure the Coil Head is snugged down hand tight).
3: Snugly screw the Aerotank MEGA Tank to the Airflow Adjustemnt Base.
4: Insert the Metal Tip into the Aerotank MEGA Tank.
How to fill e-liquid to the Aerotank MEGA：
1: Check to make sure each parts of Aerotank MEGA Tank be screwed tightly each other.
2: Screw the Airflow Adjustemnt Base off the tank.
(Tips: the Coil Head may be loosed with the Bottom Base, if so, please re-screw it again)
3: Fill E-liquid into the space between the Glass/Stainless Tube and the center metal tube.
(DO NOT over fill or get e-liquid into the center shaft.)
4: Screw the Airflow Adjustemnt Base onto the Aerotank MEGA Tank again.
How to Aajust Aerotank MEGA Airflow：
The Aerotank MEGA unique airflow valve features 1 different size airflow slide to control the airflow to the amount you prefer. Rotate the Airflow Adjustment Ring along the airflow slide, you can now adjust how hard or soft the draw is, how warm or cold the vapor is, and how much vapor is produced.
How to Clean Aerotank MEGA：
When necessary, clean the components (except the BDC coil head) by washing with clean water, and air-drying the components.
Notices of the Aerotank MEGA：
1. The Glass tank should not be impacted, dropped, or mishandled, otherwise the glass tube may be broken, and injury may occur.
2. When disassembling, please remove the Airflow Adjustment Base first, and then screw off the Aerotank MEGA Tank.
3.Do not fill the Aerotank MEGA over 3.8ml; when the e-liquid level is below 0.5ml, should be refilled to avoid a dry wick.
4. If the Airflow Adjustment Base is hard to be screwed off, please screw the Aerotank MEGA Tank with the glass tube tightly and then the bottom base will be easy to screw off.
Tips for using the Aerotank Mega BDC Bottom Dual Coil Tank With Adjustable Airflow clearomizer:
1.The metal tube in the center of this clearomizer leads from the mouthpiece to the battery end. Avoid getting liquid in this tube when filling the Clearomizer.
2.When unfastening the airflow adjustment bottom base to refill the clearomizer, the seals are temporarily broken and liquid will leak from the mouthpiece or escape into the center tube. Always wrap a cloth or piece of tissue around the mouthpiece when unfastening the airflow adjustment bottom base of the Aerotank Mega Clearomizer.
3.Fill the tank with about 3.0ml of e-liquid while tilting the tank at a slight angle and dripping e-liquid/e-juice down the inside wall of the glass (or stainless steel) tank.
4.Let the Aerotank Mega sit for a few minutes after filling with e liquid; allowing the liquid to fully absorb onto the coil wicks, leading to a better vaping experience.
5.Firing the Mega with a dry coil can cause burning of the wicking material and damage the coil.
6.When possible, keep the tank never below 1/3 full of eLiquid ("topped off"). This helps maintain the "vacuum" in the tank and prevent leaks.
7.Gurgling noise or leaks: This is a sign that liquid has found its way into the metal tube in the center of the Clearomizer (and usually occurs after a refill). Ridding the center tube of liquid will resolve the issue. To do so without emptying the tank, remove the Clearomizer from the battery, wrap a cloth or tissue around the battery end of the Clearomizer and blow through the mouthpiece.
8.The BDC coil head of the Aerotank Mega can loosen when unscrewing the tank or airflow adjustment bottom base. Always secure the coil head before re-installing the airflow adjustment bottom base of the Aerotank.
9.It is normal to find a small amount of liquid in the battery contact area when removing the Clearomizer or any atomizer. Always clean the battery threads before charging it.
10.Aerotank Mega BDC bottom dual coil heads have an average lifespan between 10 to 20 days. When the coil head wears down, it may begin to leak. Replace the coil head with a new one if available.
