How to use eGo e-cigarette, eGo e-cigarette manual, eGo e-cigarette instruction.
I. Base packaging:
a. E-cigarette eGo starter kit including:
b. E-cigarette eGo optional accessories:
II. How to use.
a. Screwing the e-cigarette eGo atomizer:
Screw and connect the E-cigarette eGo atomizer with the E-cigarette eGo battery, then will be stand-by state.
b. Screwing the E-cigarette eGo atomizer cone cover:
Screw the E-cigarette eGo cone cover with the E-cigarette eGo battery.
c. Uncover the E-cigarette eGo cartridge (the e-cigarette eGo cartridges are completely same as 510s):
Step 1: Cut the E-cigarette eGo cartridge's PE package;
Step 2: Remove the E-cigarette eGo cartomizer/cartridge cover.
d. Put the E-cigarette eGo pre-filled cartridge into the e-cigarette eGo atomizer.
Step1: take off the old inhaler and pull out.
Step2: Put the new prefilled cartridge into the e-cigarette eGo.
e.Push the e-cigarette eGo manual button.
Push the e-cigarette ego manual button for no longer than 5 seconds to avoid overheating of the atomizer, and at the same time, our battery will start protection circuit, LED light flashes 4 tims and shut down the power,
f . Charge the E-cigarette eGo battery
To charge the e-cigarette eGo battery with the e-cigarette eGo USB charger, you just screw the e-cigarette eGo battery with the e-cigartte eGo USB charger, then plug it into the PC or AC-USB Adapter. 1. the first charge should be kept for 8 hours, even if the LED light turns green. 2. Use for 20 minutes., 3. Charge the battery for another 1 hour. Your eGo battery is ready for normal using now. The normal charging time should be kept for 3 hours( even if the LED light turns green). Do not use the charger in damp areas. Do not charge the battery near a high-temp heat source. Do not weld or pierce the battery.
|
